Twitter E-mail RSS

Product Category: Prototyping

 

Evaluation board for ESP-12 WiFi Module

esp12-evaluation-board
esp12-evaluation-board
Board comes with soldered ESP-12 module and all the pins are available to the left and right of the board. In addition the UART pins (TX, RX and GND) are available at the bottom of the board. There is also a jumper which you close for programming the firmware and open to run the firmware. More Info »
Price: $9.95
by g-lab

4 X 6cm Prototype Board Perforated

4×6 cm protoboard
4x6 cm protoboard
This is high quality double sided, 4cm x 6cm proto-board. Perfect for surface mount and through hole prototyping. Features: Board: Double Sided Material: FR - 4 Colour: Green Size : 4 x 6cm Thickness : 1.6mm Pitch : 2.54mm Holes: 280 (14 x 20)  
Price: $1.50
by g-lab

USB-TTL-SERIAL-MOD

USB-TTL-SERIAL-MOD
USB-TTL-SERIAL-MOD
Assembled and tested USB serial cable with female connectors. Used  to connect to your microcontroller's (ESP8266EX), Raspberry Pi, WiFi router serial console port. Module is based on  USB<->Serial conversion chip  PL2303.  and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX More Info »
Price: $6.95
by g-lab

DFFJW-40×200 Dupont Female to Female Breadboard Jumper Wire

40pcs-dupont-wire
40pcs-dupont-wire
This is a high quality female-to-female 40 jumper wire with  Dupont 1xP connectors on each end. This cable is colour coded with 4 lots of 10 different colours all in the same order. These cables are easy to separate by simply pulling apart allowing you to customize for your application. Features Female to Female Connection More Info »
Price: $3.95
by g-lab

DFFJW-10×200 Dupont Female to Female Breadboard Jumper Wire

10pcs-dupont-wire-female-to-female
10pcs-dupont-wire-female-to-female
Features Jumper Wire with   Dupont 1xP Connectors, 10 wires with length 20cm, pitch: 0.1" (2.54mm), Colour coded.
Price: $1.45
by g-lab

Mini Breadboard

400-mini-breadboard
400-mini-breadboard
This is solderless Breadboard for prototyping. Features Dimensions 83x52x10mm Power supply bus on top and bottom Grid on 0.1" step For use with jumper-wires and our Breadboard Power Supply          
Price: $3.65
by g-lab

MB-V2 Breadboard Power Supply

YwRobot-power-supply
YwRobot-power-supply
This is must have power supply module for breadboard prototyping. It provides dual  5V and  3.3V power rails on both sides of breadboard  and  5V on USB-A socket. Features Locking ON / OFF Switch LED Power Indicator Input Voltage: 6.5 V to 12 V (DC) Output Voltage: 3.3 V / 5 V Maximum Output Current: More Info »
Price: $4.95
by g-lab
Home Product