Board comes with soldered ESP-12 module and all the pins are available to the left and right of the board. In addition the UART pins (TX, RX and GND) are available at the bottom of the board. There is also a jumper which you close for programming the firmware and open to run the firmware. More Info »
This is high quality double sided, 4cm x 6cm proto-board. Perfect for surface mount and through hole prototyping. Features: Board: Double Sided Material: FR - 4 Colour: Green Size : 4 x 6cm Thickness : 1.6mm Pitch : 2.54mm Holes: 280 (14 x 20)
Assembled and tested USB serial cable with female connectors. Used to connect to your microcontroller's (ESP8266EX), Raspberry Pi, WiFi router serial console port. Module is based on USB<->Serial conversion chip PL2303. and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX More Info »
ARM is a registered trademark of ARM Ltd. - Linux is a registered trademark of Linus Torvalds. - ESP8266EX is registered trademark of Espressif Systems. - Olinuxino is registered trademark of Olimex Ltd.
Provided sources are covered by the GNU GPL and/or LGPL licenses.
Tutorials are licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License